Scantool 2000 ECUsim Manual de usuario descargar pdf (Pagina 10)

10 ECUsim™ 2000 User Guide

5.0 Software Configuration

On startup or reset, the PIM prints the welcome banner that looks similar to

this:

STS2000 v3.1.5

The PIM is now ready to accept user commands.

5.1 Supported Commands

For a list of supported commands, see the ECUsim Programming Manual that

can be found on the ECUsim 2000 product page, at:

http://ecusim.com/2000

6.0 Advanced Operation

This section describes the operation of the simulator in different protocol

modes. It assumes that the simulator is connected to a PC running terminal

emulation software.

6.1 ISO 9141-2 and ISO 14230-4 (5 Baud Init)

After switching to the ISO 9141-2 protocol (or ISO 14230-4 with 5 baud init

option) the simulator will print the following status message:

It will not respond to any requests until the bus is initialized. After a successful

initialization sequence, the simulator will print:

<5 BAUD INIT: OK>

At this point, the virtual ECUs will start responding to OBD requests. However,

if five seconds pass without a supported request (or a keep-alive message)

being received, the ECUs will time out and the simulator will go back to

waiting for initialization:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Sin comentarios

Scantool 2000 ECUsim Manual de usuario Pagina 10